Thread Rating:
  • 1 Vote(s) - 4 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Chinese CO2 laser cutter inconsistence

I am having same problem with mine - I suspect tube is going out.... Where did you purchase replacement ( any suggestions). Are they that difficult to replace?
Reply
(05-15-2017, 03:31 PM)PlGHEADED Wrote: I am having same problem with mine - I suspect tube is going out.... Where did you purchase replacement ( any suggestions). Are they that difficult to replace?

Hi, PIGHEADED. First, check mirrors and lens are clean, verify correct calibration. After that, you can suspect from laser tube.

The most makers are in China, if you want save money (at own risk) you can purchase directly in sites such alibaba.com and others. If you want avoid (or minimize) risk, contact near provider in your zone.

Quality is very important. Cheap laser tube: less durability. I heard Reci is a good trademark.

If you know basic electricity and power suply works fine, installation is easy. First remember any connection before uninstall and power off machine. Only set positive with red and negative with black wire and prevent shortcircuit covering wire. Put water system in correct order and it's all.

Can you see a manual in this page:
http://www.instructables.com/id/Replacin...aser-tube/

I hope this be useful. Regards.
Reply




Users browsing this thread: 1 Guest(s)